|
|
|
#9
08-07-2016, 09:16 PM
|
|||
|
|||
|
I finally got the set fixed. Sort of. The circuit breaker was stuck, so I put some cleaner in it, and the set powered right up. I then proceed to do convergence, and that went very well. After that, I got the converter box and attempted to watch something. That's when it went downhill again. The brightness pot took a complete dump. It is stuck on the lowest setting. No matter which place you slide it, there is no picture.
Last edited by TUD1; 03-12-2017 at 06:57 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode