|
I started some initial work on the set. The open wire is a fuse for the tube filaments. I replaced it and after a slow power up got a rastor and some distorted sound but no video. After about five minutes, however, the filament fuse blew and now it blows instantly if I try to power up the set. My first thought was that a cap on the filament line shorted out, but there are only a few disc caps on the audio section. The electrolytics felt fine as well. Now, if a filament was shorted to ground would the tube still light? If not my thought was that the issue might be near the video output tube, since the audio is picked off right before the video output. If anyone else has suggestions of components that may be a potential source of the issue I would welcome the suggestions. Thanks!
Last edited by pendulum; 06-21-2016 at 10:36 AM.
|