Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 05-18-2016, 03:51 PM
groovy groovy is offline
VideoKarma Member
 
Join Date: Mar 2016
Posts: 9
Update

Just wanted to give an update to my troubleshooting quest for this set. After digesting the responses on this thread, I did take a good look at the CRT neck board - I cleaned the sparkgap unit with alcohol as suggested and checked the coils on this board along with checking for cold solder joints - everything checked out OK. I then decided to take a look at the screen control - this is separate from the flyback. I discovered that if I just touch the control, it caused a big fluctuation in the screen - bringing on the bright screen with retrace lines. Of course I figured it was dirty, so the most I could do was to rotate the control since it would have to be removed to clean - rotating didn't help. By shear luck (I believe), I was able to find a brand new in box focus/screen control unit for this set from Moyer Electronics in Pennsylvania for around $30 with shipping. I installed the new control this past Saturday and have had no reoccurrence of the bright screen with re-trace lines. I am convinced that there was something wrong with the old control as it was very sensitive to touch causing major changed in brightness. This control is more complex than just two potentiometers - it is a divider network with resistors integrated into a cermet board.

So far, no bright flashes. However, I still get the occasional red flicker - so something else is still up in this set. I dialed in the driver and bias controls again - along with the screen controls per RCA specs and also using a color meter, calibration software and DVD screen patterns - so I have excellent greyscale and color. The picture is excellent - except for the occasional reddish flicker - it is almost like an increase in the flesh tone - not a full on saturation. Maybe a leaky transistor or cap. I didn't change the video buffer transistor or the power regulator transistor as mentioned in responses on this thread - I did source them and may change them next. The only other thing I did change was the main filter capacitor. I didn't have to pull the chassis to change the filter cap or the focus/screen control.

I have attached pics of the chassis and new control. Thanks for the responses, it helped and any other input on this reddish flicker is appreciated!
Attached Images
File Type: jpg IMG_0084.jpg (81.3 KB, 30 views)
File Type: jpg IMG_0055.jpg (90.8 KB, 45 views)
File Type: jpg IMG_0059.jpg (116.8 KB, 40 views)
Reply With Quote
  #2  
Old 05-19-2016, 10:19 AM
zeno's Avatar
zeno zeno is offline
VideoKarma Member
 
Join Date: Mar 2013
Location: New Hampshire
Posts: 4,918
If the set has OSD look to the tuner pkg next. The
OSD was in there, also check the joints where the 2 parts
plug together. Also recheck the CRT board for joints
especially at the R- out transistor.

73 Zeno
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 09:36 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.