Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #2  
Old 05-09-2016, 04:21 PM
timmy's Avatar
timmy timmy is offline
VideoKarma Member
 
Join Date: Jan 2011
Location: Delaware ny
Posts: 3,719
Well ok what I wrote above was off a bit, what happened is I put the set on and the sound and picture was a bit fuzzy and after a few seconds both cleared up so I turned it off and Alittle later put it on and there was no sound or picture then I had done what I had wrote in the last post. Shorting out the neg tube came after because I was in doubt about the caps that were in the set to begin wth so I parallel one and messed up. But the sound and pic just went out and I subbed all Micas in that circuit as well as tubes and found one resistor and replaced it so it seems as if the IF is simply dead and can't find out why. Even tried another source for video and no good. Any help would be greatly appreciated!!! Is there another part of a black and white chassis that would prevent the IF from working ?

Last edited by timmy; 05-09-2016 at 04:58 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:08 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.