![]() |
|
#3
|
||||
|
||||
|
I see very little evidence of repairs. Even the original thermistor and filament dropper are here.
![]() I wasted no time i pulling the main board out and fully recapped it including new couplates. ![]() I also replaced the flaky power switch with a NOS one. ![]() I did a full recap below too including replacing the filament dropped with some new power resistors. ![]() Tested all the tubes and only the 12DQ6 and two 3BZ6 tubes were weak. Ready for a power up test!
|
| Thread Tools | |
| Display Modes | |
|
|