![]() |
|
#15
|
||||
|
||||
|
Quote:
It most certainly was NOT "realigning" the coils! The alignment range on my oscillator coils if FAR too small. In fact, except for (current) channels 3 and 4 its insufficient to get the sound carrier to tune properly into range of the fine tuning, which even on 3 and 4 barely has enough range. The coils were actually rewound. This is obvious looking at them. The tuner design is very, very bad indeed. The main problem is that the tuning wafers on the switch are too large in diameter, meaning that wires are too long. The coils are too big. Some are not even coils ... they are straps that are very low inductance. In fact I had to augment the width of one by soldering on a strip of copper sheet about 3/16 x 3/4 inches to get one coil to tune correctly (to the "intermediate" channel set to which my set is tuned.). I do note that I have tried heterodyning "cable series" channels down into range of channels 1, 2, and 5 (oscillator frequency under the incoming frequency) and they work fine by fine tuning the frequency synthesizer. Also the 6J5 was likely the best tube to use, in its time, but still, the distance from the socket tabs to the tube elements is rather too long. Last edited by dtvmcdonald; 03-10-2016 at 10:08 AM. |
| Audiokarma |
| Thread Tools | |
| Display Modes | |
|
|