![]() |
|
|
|
#1
|
||||
|
||||
|
Have you checking your HV directly on pin 2 of the 1B3? Possibly the 1M resistor in series with the HV lead?
|
|
#2
|
|||
|
|||
|
Is the large resistor, R209 in the HV cage good?
They refer it as horizontal linearity control, but it has a bearing on the boost. The one in my 621TS is open. The sweep circuit is similar.
|
|
#3
|
||||
|
||||
|
Quote:
If unloaded you are getting 8.5kV and it drops when the brightness is turned up, it would appear the 1 Mohm has drifted upward in value.. it is easy to check: pull the 1B3 and mesure from the socket to the 2nd anode lead. |
|
#4
|
||||
|
||||
|
Quote:
I am measuring the HV upstream of the 1M resistor, directly at the 1B3 filament. The 1M and 3.3 ohm resistors both check OK with a DMM. I may replace them anyway as it looks like I will be digging into the 1B3 socket wiring anyway looking for leakage and possibly swapping a flyback to test. |
|
#5
|
|||
|
|||
|
Quote:
|
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|