![]() |
|
|
|
#1
|
|||
|
|||
|
Whoa, nice looking set. That cabinet doesn't look like it even needs much attention Plus you got the knobs to finish your 29t926. Can't beat that. You are a porthole magnet.
![]()
|
|
#2
|
|||
|
|||
|
Ok I hate to jump someones post but does anyone have a good 12UP4 to sell? Also could use the left side knob door Thanks and sorry again
|
|
#3
|
||||
|
||||
|
A classic '40's porthole TV! Nice find. I'm going to say it's a '48 with it's prismatic panels, but so many models spilled over a year after their original production date.
|
|
#4
|
||||
|
||||
|
PM sent
__________________
Vacuum tubes are used in Wisconsin to help heat your house. New Web Site under developement ME http://AntiqueTvGuy.com |
|
#5
|
|||
|
|||
|
Just sold one last week to a member here for 50.00
|
| Audiokarma |
|
#6
|
||||
|
||||
|
Restoration is under way on this porthole. I've replaced a couple open sand coated resistors and as many capacitors as I had replacements on hand for. This set has 7 multi section electrolytics, so I have got to order plenty of those too. I'm amazed at how many bumblebee caps and white colored caps are cracked open on this set. Many 1meg+ resistors are lower in value, instead of the normal drift above value. I'll finish correcting the horizontal rolling on my 1951 Philco 16" while I'm waiting on parts.
|
|
#7
|
||||
|
||||
|
Mr. Muntz would have had a stroke looking at the bottom of a set that late,
looking like that. Far too many parts! |
|
#8
|
||||
|
||||
|
I agree. Luckily Ive restored a few portholes already, as these are not for the faint at heart. The schematic shows the 16", which is a little different than my 12" set. Many cap values are different and in different places. A definite tip is to oil the fine tuning mechanism before using. They get sluggish over the years and won't turn, breaking the dial string. The dial string goes through the center of the chassis and is very difficult to get to and restring.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|