|
|
|
#6
02-19-2016, 10:53 PM
|
||||
|
||||
|
Just change those 0.022uf coupling caps, and check voltages. I think the 200V voltage rating is too low, 400V would be better, also check the 150 ohm reaistor for value and that the cathode bypass cap C10 isn't shorted. I wouldn't be surprised if the electrolytics are fine but the coupling caps could be leaky.
The plate voltage is fine, just use good tubes.. Last edited by maxhifi; 02-19-2016 at 10:56 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode