![]() |
|
|
|
#1
|
|||
|
|||
|
...
Last edited by andy; 11-20-2021 at 04:19 PM. |
|
#2
|
||||
|
||||
|
A few things to watch on early XL100's
Cold joints around the pin transformer. Cold grounds from main chassis to mother board. Module sockets crack & go int. If any of these it should act up when tapping around. On the 17" sets vert sockets were a BIG problem. They would crack & cause the module PCB to burn up. New socket & a module with no dud value was costly. If none of that start with 'lytics from the output then back. 73 Zeno
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|