Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #16  
Old 01-07-2016, 02:54 PM
rrrhre2s rrrhre2s is offline
VideoKarma Member
 
Join Date: Nov 2013
Posts: 38
The capacitor that causes the board to keep blowing the HOT is located behind the HOT heat sink 47uf at 16v across two low value resistors (value varies with version of the board. This capacitor was a CX meaning it was related to safety.

Run the set 15 minutes remove power check the temperature of the HOT heat sink if more than just warm replace the capacitor.

Later boards were reworked to eliminate the 2 resistors and capacitor in parallel. Note the driver circuit was also changed.

9-160-06
R3324 replaced with a jumper.
R3334 0.18 ohm 3w

9-160-05
R3324 0.33 ohm 3w
R3334 0.18 ohm 3w

Have problems reading the copy I have may have the numbers wrong.

The 0.18 ohm resistor is on the emitter of the HOT.

The 0.33 ohm resistor is between the base and the horizontal driver transformer.

rrrhre2s
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 05:30 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.