![]() |
|
|
|
#1
|
||||
|
||||
|
I replaced the bad electrolytic as well as the ceramic tubular caps. I now get a color picture with very poor contrast and diagonal horizontal lines. Two of the attachments show the picture with a signal, one should be snow. The brightness and contrast controls have no effect on the picture. Color and tint do. The vertical is also very unstable. I got a copy of the Sams schematic I can reference.
|
|
#2
|
||||
|
||||
|
Looks like a loss of the VIDEO signal. You have COLOR....but NO video 'behind it" to "control it". Looks a LOT...like an open delay line.
|
|
#3
|
|||
|
|||
|
Classic case of loss of the luma signal with color information intact. Most frequently caused by
1. Dirty service switch (if set has one). 2. Heater-cathode short in the CRT. It will usually show up by tapping on the CRT neck. (The video/luma signal does not "control" the color signal. They are two separate signal chains.) |
|
#4
|
||||
|
||||
|
By"control" I mean it gives the chroma it's LIGHT and DARK information, allowing it to accurately produce the correct shades of color. Without the luma...you get ONLY blotches of color info, that does NOT look anywhere useable...
And YES...make sure the service switch, if any, is not dirty, or has NOT been accidently placed "midway", or broken off. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|