![]() |
|
|
|
#1
|
|||
|
|||
|
Quote:
EDIT: got the belt fixed but now it seems like its a timing issue as for some reason the VCR won't go through the power-up sequence properly which then shuts down the machine, and I've tried re-timing the loading mechanism underneath but every single time it goes back into the wrong timing and makes the loading mechanism jam up which causes the machine to shut down during the power up sequence. I've fixed timing issues before on older Panasonic and Quasar Machines pretty successfully but never really worked on Zenith/JVC units before very successfully. Any ideas as to how to fix this timing issue? Last edited by Captainclock; 10-14-2015 at 09:21 PM. |
|
#2
|
||||
|
||||
|
I worked on a couple of those in the 90's but can't remember what the mechanism looked like. You may have a flaky mode switch, I think that was the era for them. Try cleaning it with FaderLube.
|
|
#3
|
||||
|
||||
|
Mode switches were a problem. Also there were a few screws
that needed tightening on some JVC/Zeniths but I dont remember the ones since I almost never did VCR, I hated them........ IIRC it was under a PCB on the bottom. I would ask the VCR man but sadly he is dead now. BTW I still got one of these units. Dont use it often but its never let me down. |
|
#4
|
||||
|
||||
|
Quote:
I would always shoot a little dab of DeOxit into the mode switch too. |
|
#5
|
|||
|
|||
|
OK Thanks for the tips, I'll take a look into those issues, especially the mode switch. Where might I find the mode switch in this VCR?
Also Blast, the mechanism for this VCR is a large flywheel type gear (similar to what the old record changer mechanisms used except scaled down for a VCR Mechanism) that's attached to a small wormgear that's got a belt path attached to one side that then attaches to a motor that drives the whole mechanism. |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|