![]() |
|
|
|
#1
|
|||
|
|||
|
Here's a better shot of it:
![]() I clipped a lead and tested it. If it's the boost diode, it tests open both ways. |
|
#2
|
||||
|
||||
|
Quote:
Only two ways to check - with the set on, measure the Boost (~900-1100V - more than a DMM can handle) with a VTVM =OR= replace the rectifier and run the set.
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! |
|
#3
|
||||
|
||||
|
At SOME point...you MUST check that CRT. As much as we hate to admit it...sometimes they DO die.....and sylvania tubes seem to die quicker than most.
Hopefully...it is NOT the tube--but you DO need to know. I have had sets before...with tubes SO waek on all three guns...they just would NOT hardly light....till "pounded on" with a rejuvinator... At least THEN...you will know. ANd if it is NOT the CRT...I would look for a near total loss of video drive and such....assuming all voltages for the CRT screens and such are ok. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|