|
|
|
|
|
#1
09-23-2015, 07:37 PM
|
||||
|
||||
|
Quote:
 
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! 
|
|
#3
09-23-2015, 10:41 PM
|
|||
|
|||
|
Another fairly frequent problem with some of those was the H oscillator failing to start or being hard starting. Since the plate is supplied form B Boost, sometimes there isn't enuff juice on the plate for the osc. to start.
A quickie fix is to connect a diode (an ordinary rectifier diode) as shown, from the Boost line to B+. That way, the osc starts on B+, and then when the Boost comes up, the diode becomes reverse-biased and the osc runs on Boost as designed. Since the design used low (135V) B+, the H output stage doesn't get hot enough to red-plate when there's no grid drive.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
