Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Solid State CRT Televisions

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #13  
Old 08-08-2015, 03:57 PM
zeno's Avatar
zeno zeno is offline
VideoKarma Member
 
Join Date: Mar 2013
Location: New Hampshire
Posts: 4,918
9-160 removal. Hope I remember everything ! Been years.
If the board has been out some things MAY have been
left out. Uses all 1/4 inch bolts.

Unplug set.
Put a clip lead on the CRT shield the other end to a thin
well insulated screwdriver. Put under HV lead & move around.
Remove HV lead.
Either a plastic or metal bracket goes from flyback to frame, remove.
Along the bottom is a plastic holder held with 1 bolt remove.
On top of board near 2 connectors is the key. Its red & sometimes
wrapped in tap Twist it 90 degrees & pull it out.
Rear edge connectors may have little black steaks. Remove & dispose.
Unsnap all edge connectors.
IIRC there are 4 to 5 top connectors, unplug.
Undo focus wires from FBT to CRT socket board. Its a flying connection.
Unplug ground wires from CRT shield & one from spark gap at
rear edge of board usually.
On either side of the PCB there are claws holding it in. Push
down on them & work the board out.
Be careful of the edge connectors you can smash them easily.

Sounds like a lot but after a few times you can R&R it in
less than 2mn. You CAN NOT put it back wrong, its got keys on
everything.

73 Zeno
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:30 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.