![]() |
|
|
|
#1
|
||||
|
||||
|
This looks like a higher end System 3 set from about 1980-'81 and will likely use a 9-160 power supply/horizontal sweep module. It's also this module that's most likely the problem. Usually, when they do what this set is doing, it's due to bad solder connections on this module.
__________________
http://www.youtube.com/user/radiotvphononut |
|
#2
|
||||
|
||||
|
Quote:
I'm not even sure where to look inside at what to repair. I'm a Sony guy. Zenith is new to me. Never serviced one. |
|
#3
|
||||
|
||||
|
I owned one. Probably an SM1971P. Top of line 19" at the time.
System 3 with 9-160 hv/power supply board. Also has an early comb filter & gives an outstanding pix. Its also a clock TV that can be set to turn on & off. And its full RAT cable ready with add/skip. The cats ass in 1981 With phone plugged in the TV will ring. Press a button & the set mutes & you talk & listen to TV. You can also make calls on the TV using the remote. The OSD shows the phone ##. Very expensive new so not a lot sold. This is a keeper IMHO. In any case dont scrap it ! When you get it open we will help with it, there are hidden tricks to getting the board out. BTW for the phone you NEED the right remote. All other functions work with any Zenith IR remote. 73 Zeno
|
|
#4
|
||||
|
||||
|
Quote:
So what do I have to do, to remove this 9-160 power supply I keep hearing about, and what on it would I need to replace on said board to bring it back to life. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|