|
alignment is something of an art as well as a science. As mentioned the need for calibrated test equipment, the correct procedure for making terminations of test gear, correct load blocks, correct bias settings, correct lead dress, all comes into play, even then its not for the faint of heart.
Just moving your hands around can upset the look of the bandpass on a scope, even tube jockeying can effect it. Unless you know someone has been messing with the coils its really best to leave it alone or as mentioned start with a set you don't care about. That way when you strip the IF thread out of the forms, or crack a slug from using the wrong tool, or do some other serious damage, at least its not a big loss.
With practice you can get start to get the feel of it, but generally its not needed on anything made from the 1960's on up, again unless it was tampered with or a major part (like a coil) had to be replaced.
there are lots of you tube videos out there that you can check out, just to see what others have done.
|