Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #29  
Old 04-08-2015, 03:55 PM
Tom Albrecht's Avatar
Tom Albrecht Tom Albrecht is offline
VideoKarma Member
 
Join Date: Mar 2010
Location: San Jose, CA
Posts: 683
V12 (vertical output) gets its plate voltage for both sections (pins 2 and 5) from the focus control, which in turns gets its voltage from a resistor chain fed by the HV.

You correctly note that your voltages on pins 2 and 5 (+140 V and +43 V) are too low, telling us that something is wrong.

There are probably two main ways this can happen:

1. Not enough drive signal from the vertical oscillator. If the signal on the grids of V12 are too small, then both triodes will tend to conduct too much, pulling their plate voltages low.

1a. If the grid drive on just one of the two triodes is too weak, it could still cause this problem. One way this could happen is if there is a problem in the network that feeds the inverted signal to the second triode (grid = pin 4). Can you confirm that C65, R65, R64, C67, C66, and R62 are all correct value and good?

2. Supply voltage to anodes is low. This is fed from the high voltage through the following resistors: R4, R5, R80, R81, R82, R83, R3, R61, R63. Have you confirmed that all of these are OK?

Is your HV correct? Do you have a HV probe to confirm that there is 4-5 kV there? If you don't have a HV probe, let me know and I can suggest how to use a microammeter (if your DVM has this function) to read your HV.

(edit: sorry, didn't see the posts on the new page yet when I wrote this reply -- see below)

Last edited by Tom Albrecht; 04-08-2015 at 04:02 PM.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:13 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.