![]() |
|
|
|
#1
|
||||
|
||||
|
Switching supplies often radiate their noise thru the AC mains wiring and sometimes the DC output too. You may or may not get a noticeable noise drop if you move it 10' or half a block...
The electric octopus is not a danger as long as you don't overload anything (most are too dumb to check so they advise not to do it, assuming everybody is dumb). Electricity can handle as complex and messy a path as you can give it (the CPU chip in your computer is billions of times as complex as your little rats nest), and remain well behaved as long as you observe ratings and rules.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
|
#2
|
||||
|
||||
|
I found that combining all 4 in the little "nest" causes a buzzing as one of them is vibrating just enough to resonate when bundled.
I'm going to try and move the supply and lengthen the DC output line. Do you think a cap across the DC leads might help if there is noise there? Also, I don't think it's going back along the AC as it's being radiated to the antenna input of the TV. Thanks
__________________
Pioneer SX-1080, Pioneer PL-115D, Pioneer CT-F9191, Pioneer RG-1, Wollensak 8050A, Akai 4000DS MkII, Pioneer CS-05 & Polk 1.2TL Denon 5803A, Pioneer DVL-700, Pioneer CT-W603RS, Toshiba HD-A3, D-Link DSM-520, Dish VIP-722, Polk 1.2TL, CSi5, LS/fx, RT-800 and PSW-650 |
![]() |
| Thread Tools | |
| Display Modes | |
|
|