![]() |
|
|
|
#1
|
||||
|
||||
|
Sorry there Z I guess I missed a few pages in the middle of your story.....
In #39 you have the assembly removed. A possible fix could be laying it down like you did, put it in as close a position as possible, and tracing out the outside perimeter of it, and making a plastic holder for it - a big circle - with cutouts for the "cloverleaf" and silicon glue the plastic circle to the CL - maybe put shims along the way to get position just right..... Might be more rigid than springs.... and not interfere magnetically..... 1/4" or thicker sheet plastic..... Maybe even polypropylene, or polyethylene.... A little softer, and immune to a lot of stuff..... Give it less brittle start.... .
__________________
Yes you can call me "Squirrel boy" |
|
#2
|
||||
|
||||
|
Quote:
|
|
#3
|
||||
|
||||
|
I got better results with another alignment. Here is a picture of the sweep with the marker at 42.75 Mhz and 45.0 Mhz. And a picture of the multiburst showing 0-4.5 Mhz making it through the tuner to the first video amp. This alignment also reduced the ringing of the single vertical line, as shown in the magnified scope image in the fourth picture. The last is what this alignment looks like on the CRT. I think this alignment is a keeper.
Dave Last edited by Zenith6S321; 01-21-2017 at 06:33 PM. |
|
#4
|
||||
|
||||
|
I went through the audio alignment which fixed the distortion in the sound and increased the volume a lot.
Neither of the yoke centering adjusting strings would move. I took the yoke off the CRT and was then able to move the strings a little. Working them back and forth a bit seemed to free them up. I put the yoke back on and fired up the set to try to use the centering strings. The strings moved the centering rings but for some reason the image on the CRT does not move. I wonder what I am doing wrong. The image does fill the CRT and the centering is not off by a lot. It still would be nice to get it centered though. Dave |
![]() |
| Thread Tools | |
| Display Modes | |
|
|