Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #21  
Old 02-12-2015, 01:16 AM
EdKozk2 EdKozk2 is offline
Tinker
 
Join Date: Mar 2014
Location: Elkhorn, WI
Posts: 542
Make sure you have your focus control in the fully ccw position when you take your voltage readings on the 12au7 and 6au6 sound I.F tubes.Your cathode supply voltage
on both those tubes is +115vdc and the plate supply voltage is +265. Your cathode resistors of 220 ohms only drop about 1.5 to 2 volts. Check R-60 the 22k resistor connected to pin 5 of V12 and ground, that forms the final leg of your power supply bleeder, 115 volt to ground. An open or way off spec 22k resistor could through the readings off. The sync clipper is a DC coupled to the sync amp. The sam's also notes that the pin voltage readings are between various supply voltage points, e.i. 115 and pin 6 of the 12au7. A shorted capacitor would tend to burn a resistor ,a transformer,and blow itself up even.
Ed
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 10:50 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.