![]() |
|
|
|
#1
|
||||
|
||||
|
well im not sure if the problem here is in the blanker circuit but the g1 is 159v bright up and bias ccw. otherwise the voltages are close depending where the rgb drives are. but i cant set it up unless the bias is maxed, thats not right, so im looking...
|
|
#2
|
|||
|
|||
|
thats a bit on the low side, but you need to find out what the cathodes are, those are directly coupled to the video out tube. You want approx 100v difference in the cathodes to G1 voltage (cathode should be higher).
the greater the difference the more cut off the tube will be (darker). It does not take a lot of change to go from dark to bright. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|