![]() |
|
#17
|
||||
|
||||
|
Just to clear up Jeffhs fuzzy description of the service switch. The line position of the service switch was not often used for convergence, but rather gray scale adjustment. One would drop the brightness and color controls to min, enter the line mode of the service switch, turn the screen/G2 controls down, increase red until faint line appeared, increase green until line became yellow, increase blue until line turned white, then return service switch then brightness and color to normal positions...If whites looked tinted after that adjustment of color drive controls with a black and white picture would be the next step.
The blank raster position of the service switch could be handy for purity set up if you left your pattern generator at home. Purity with a blank raster can be achieved by turning the blue and green G2 controls down for a red raster, sliding the deflection yoke back until the screen looks tie dye, *centering the red dot using the purity rings, then sliding the yoke forward until the screen is completely red and readjusting the green and blue G2 controls. If you find that need to do a purity adjustment after you get the color demod working right a good short cut is to use a test pattern DVD with a fully red screen to do the purity without messing with the switch or the G2 controls. I find the G2s generally are more stable than purity, and I hate to mess with the G2 once I have them set just the way I prefer them. *a degauss of the screen before this may be necessary.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
| Thread Tools | |
| Display Modes | |
|
|