|
|
|
|
|
#2
01-17-2015, 05:36 PM
|
||||
|
||||
|
The MICM units are factory set to desired channel. Probably possible to reset them, but good luck finding schematics or instructions to do so. B-T doesn't make that stuff available.
They do use a PLL synthesizer, so probably a simple matter of programming rather than component replacement. But you would need to reverse engineer the programming interface and protocol. Last edited by N2IXK; 01-17-2015 at 05:49 PM. 
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
