![]() |
|
|
|
#1
|
||||
|
||||
|
If with the color control up you still get the same bars as in post 20, then what you need to do to fix it is look for the 3.58Mhz Chroma reference transformer, and adjust it's slug until it synchs...At that point the color bars should go away and you should have a color picture, though it might still look a bit funny if the front tint/hue control is mis-adjusted.
__________________
Tom C. Zenith: The quality stays in EVEN after the name falls off! What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4 |
|
#2
|
||||
|
||||
|
Quote:
|
|
#3
|
||||
|
||||
|
Rapid progress ! Nice work. You cant beat these sets to
learn & experiment with. If the color is lined up properly you should be able to change channels WITHOUT the color coming on with color bars before locking in. If it dont deal with it later. Next is the minor width problem. Be SHURE you are actually turning the HV reg control, see if it goes from stop to stop. Most had an odd adjustment that you had to jam a tool in to get it to move, not just the usual screwdriver adjustment. HV controls with a bad spot give exactly the minor width problem. The filter can is a quick test but the sides are strait so I think thats OK. After that scare up some KNOWN good ( not tube tested ) tubes. When the width is fixed its time for a complete CRT set up. 73 Zeno
|
|
#4
|
||||
|
||||
|
Quote:
As for the tubes, I should get an 6LF6 and the 3 others as well? |
|
#5
|
||||
|
||||
|
Quote:
no other uses so should be much less. It depends on if you want to possably wait & pay another shipping charge etc. 73 Zeno
|
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|