![]() |
|
|
|
#1
|
||||
|
||||
|
What an unusual power supply, an autoformer to get B+, series string heaters, and thus a hot chassis. Guess the cost of isolating a hot chassis was less than the additional cost a full power transformer would have cost...
__________________
|
|
#2
|
|||
|
|||
|
try a new 6BN6 too.
|
|
#3
|
|||
|
|||
|
tried the adjustments as stated , the quad really doesn't do too much , the way it is now if you set to good contrast , not too much it has a loud buzz , if you adjust it so it is grey with just barely enough contrast it is tolerable , if you adjust the agc to wear it is very grey and almost no more signal the buzz is pretty much gone , maybe the cap on the quad is shot
tried more then one 12at7 with no luck |
|
#4
|
|||
|
|||
|
The quad coil should show a sharp peak at resonance. Check it for continuity if it doesn't.
Last edited by old_coot88; 12-18-2014 at 10:57 AM. |
|
#5
|
|||
|
|||
|
old coot thanks i didn't think of testing to see if the quad coil was open / ok , if not where the hell do i find one ?
|
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|