Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early Color Television

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 12-16-2014, 11:39 PM
Penthode's Avatar
Penthode Penthode is offline
VideoKarma Member
 
Join Date: Jun 2009
Location: Kitchener/Waterloo Ontario Canada
Posts: 1,463
I finally got around to rewinding the quadrature injection transformer (T20) on the Zenith. Recall it suffered from heat and crumbled when I attempted to adjust it.

I found an appropriate coil form from an old unused RCA AM/FM radio IF transformer. I had to make two attempts at rewinding because of a misassumption the first time I tried which resulted in initial failure. I could only achieve proper quadrature demodulation with the demodulation axis rotated 90 degrees! I could get a decent picture with relatively good color if I swapped the B-Y for R-Y, G-Y for B-Y and R-Y for G-Y and touch up the quadrature injection. The only difference from the original Zenith transformer and mine was the input coupling winding (pins 2 and 7 on the transformer). I simply bunch wound the winding.

The original winding was a "honeycomb" mesh winding. I reckoned there was too much distributed capacity in my bunch winding. The bunch winding I believe was bringing the primary winding towards resonance: this would add the 90 degrees shift. Fortunately the AM winding from the IF transformer I dissected had two similar honeycomb windings. I used one to determine the total number of turns at 110 per winding and the second I removed the difference to provide the 37 turns I required. I assembled the transformer so that it appeared almost identical from the original.

With my second transformer reinstalled, I was able to get the correct quadrature alignment and demodulation phase with no problem.

The color lock was poor after completing the color oscillator adjustment. Probing with the scope, The burst amplitude low due to the a bad 6JC6 burst amplifier. I found the color oscillator would intermittently lock in phase 180 degrees out! I could find nothing amiss and decided to change the 6KT8 oscillator/reactance control tube for the heck of it. Color lock was now excellent. (I decided to replace all the 6KT8s in the set because I do not trust the critters).

I really like the picture on this set: it is crisper than my RCA's and I really like the Zenith picture. I did not bother with Video IF/ Sound IF or chroma channel alignment because the picture and sound are good. The picture indeed looks better than the photos. The set is using the original Zenith CRT.

The CRT looks to have had a hard life but appears to have a lot of life remaining. Sure glad it wasn't necked!
Attached Images
File Type: jpg Quadrature Injection Coil.jpg (126.6 KB, 42 views)
File Type: jpg Zenith 24MC32Z Chroma section.jpg (127.8 KB, 35 views)
File Type: jpg Zenith 24MC32Za.jpg (58.6 KB, 71 views)
File Type: jpg Zenith 24MC32Zc.jpg (48.3 KB, 71 views)

Last edited by Penthode; 12-17-2014 at 02:02 AM.
Reply With Quote
  #2  
Old 12-17-2014, 12:12 AM
DaveWM DaveWM is offline
VideoKarma Member
 
Join Date: Feb 2009
Location: Orlando FL
Posts: 5,607
looks great, excellent convergence as well. That set sure has come a long way, great work!!
Reply With Quote
  #3  
Old 12-17-2014, 12:22 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
PLEASE take your right hand, reach behind your left shoulder, and pat yourself on the back! Well done - another Zenith beauty!

Congratulations on the engineering and persistance!

Cheers,
__________________
Brian
USN RET 22YRS (Avionics/Cal)
CET-Consumer Repair and Avionics ('88)
"Capacitor Cosmetologist since '79"

When fuses go to work, they quit!
Reply With Quote
  #4  
Old 12-17-2014, 03:18 PM
Kevin Kuehn's Avatar
Kevin Kuehn Kevin Kuehn is offline
Workin' Late Again
 
Join Date: Jan 2011
Location: WI
Posts: 3,976
That picture really looks wonderful.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:38 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.