![]() |
|
|
|
#1
|
||||
|
||||
|
The IF is the intermediate frequency section of the receiver, whereby the carrier signals sent out by the transmitting station (or other analog RF source) are demodulated, mixed, and converted into baseband signals which the rest of the TV's circuitry can work with. For instance, an NTSC signal is 6MHz wide, per VHF or UHF channel. In that allocated bandwidth lies the color subcarrier which is extracted from the station carrier, along with the sync pulses, sound, and actual video information.
What I was suggesting in my earlier post is to attempt an alignment of the Sound IF section, which sometimes contains adjustable coil for the trap or an additional discriminator coil. To perform this procedure, you typically require some test gear, consisting of an sweep/marker-generator, a suitable oscilloscope (dual-trace is preferred), and the original documentation specific to your set. It really does help, IMO, to have the original documents, since they often outline the exact curves you are seeking to replicate, and a bunch of other test data. |
|
#2
|
||||
|
||||
|
What is the model number? Hitachi service data that I have is by model, not chassis. Should be a CTXXXX model number. Hitachi sets of that vintage had a pretty good AGC action, and it may be as simple as backing off of the AGC control. Too early of a set to have a jungle chip, so it's likely an easy fix for the buzz.
Lemme know the model and I'll see if I have a copy of the service data, archived by Hitachi in TIFF format. Cheers,
__________________
Brian USN RET 22YRS (Avionics/Cal) CET-Consumer Repair and Avionics ('88) "Capacitor Cosmetologist since '79" When fuses go to work, they quit! |
![]() |
| Thread Tools | |
| Display Modes | |
|
|