![]() |
|
#6
|
||||
|
||||
|
Quote:
Since then I'd troubleshot the problem, and to get right to the point, yes, I think there was a design problem. Highly saturated chroma that appears a few microseconds in from the beginning of horizontal sweep does not cause the anomaly, because it occurs far out of range of the keying pulse trailing edge. Highly saturated chroma, which appears right at the beginning of the horizontal sweep, occurs close enough to the keying pulse trailing edge to literally climb up the edge of the pulse, slide onto the top of the keying pulse, and infect the color burst with chroma. This anomaly can occur because rotating the horizontal control varies the phase of the horizontal oscillator enough to shift the timing of the keying pulse -- and drive it into the garbage chroma signal. Why garbage? Because the color burst is tapped from the plate of the 6CL6 first video amplifier by a tiny (3 pF) cap that can't help conducting some of the chroma signal as well. (Of course, if there is no chroma there is no chroma signal, which is why, if there is white or black at the beginning of the horizontal sweep, there is no chroma to contaminate the color burst at the top of the keying pulse, and the anomaly under discussion does not and can not take place.) Only highly saturated chroma signals cause the anomaly because only large signals will be great enough to get through the 3-pF coupling cap in sufficient amplitude to cause color burst contamination. Another quick point: I believe Philco, when designing its first color TV, the Model 22D5102 with the TV 123 chassis, ran into the same problem as RCA with its CT-100. Philco's fix was to add a pot to the horizontal oscillator circuit that was adjusted to limit the range of the horizontal hold control. I have been fleshing out that ETF PPT video; when finished I will try to make it available if there's interest. Of course, there's still the chance that it's an alignment problem... but I'm beginning to believe not. Pete Last edited by Pete Deksnis; 11-23-2014 at 12:52 PM. |
| Thread Tools | |
| Display Modes | |
|
|