|
|
|
#11
11-04-2014, 08:13 AM
|
|||
|
|||
|
if you have done all that them I am out of ideas. It sounds like a regulator problem. Voltage checks should narrow it down.
Just to clarify you have max of 23kv with the CRT dark and the HV pot maxed out. You remove the cap from the regulator and it goes over 28kv You have tried KNOWN good shunt tubes. You have check the HV pot (and its ground is good) you replaced the .0033 grid to cathode cap. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode