Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #23  
Old 11-02-2014, 08:42 AM
ronl ronl is offline
VideoKarma Member
 
Join Date: Jun 2014
Location: Surrey (near Vancouver) BC Canada
Posts: 222
Hi Mips.
from what i gather without reading the schematic( gotta dig it out), most readings/waveforms use the chassis as ground for the test equipment with gear this vintage.check the footnotes on the schematic-it should say if the voltages/waveforms are taken with repect to chassis ground.

from what i have seen from your pictures-the last problem is width...tv width looks acceptable-some of these vintage sets never had perfect width or control of width.

i would try retaking those waveforms with the scope set in the "u" (horz)range?
might see they match the expexcted waveform? iirc,1 horz scan line is aprox 63.5 us or microseconds or 1/15750

not sure at this point without looking at the schematic why you are getting 60 vac with respect to ground-i suspect you are using a isolation transformer while working on this set so should be safe but will get back to you once i dig schematic out.
is picture good at this point other than width being a little wide?
just some thoughts.
RonL
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 02:36 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.