![]() |
|
|
|
#1
|
||||
|
||||
|
Quote:
matching item on it, and includes a trim cap that you make sure the little test wave looks square when tested. It's on the front of that scope, 1khz test I think it says... 1khz at something like .5v... if the probe has also a 10X divider built in, you will have a switch that will divide your signal source by 10. 100v signal will max at 10v. I use to use home made probes with rg6 and connectors from RS, just be careful where you stick it, you don't wanna overload the vertical amplifiers in the scope. AND most important, check to be sure your potential between ground for the scope, and ground on yer test item is 0V. Be aware Hot chassis sets can make cool sparks shows if you ground a ground to a not so ground ground. Also check the sensitivity of the brightness control, it may be noisy and flash the screen. But mostly as mentioned, the sync will flash the screen if it's not running freely enough. If you hook up your ch1 to the test point, and sync off ch1 as well, you should see a stable square wave, and the sync should lock, and you should be able to get a stable screen... turn the variable sync threshold you should see it lock at one end, and maybe even stop scanning, and lose sync at the other extreme... .
__________________
Yes you can call me "Squirrel boy" Last edited by Username1; 10-12-2014 at 03:44 PM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|