![]() |
|
#2
|
||||
|
||||
|
A voltage source that is too high when others are normal means something using
that 130v is not working. With all circuits working the current draw will cause a voltage drop across r29 so it all works out to 130v. Check those circuits not working, be sure all the tubes are working, correct voltages all around. A tube turned off will not draw its share of current, making a smaller voltage drop across r29. Open load resistor, or tube in cutoff, possibly 2 problems. A single tube, or 2 section tube not lighting up.... no current flow.... Be sure all wiring problems have been found. double check, everyone overlooks things... .
__________________
Yes you can call me "Squirrel boy" |
| Thread Tools | |
| Display Modes | |
|
|