Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Diagnostic & Test Equipment

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #2  
Old 09-27-2014, 12:36 PM
N2IXK's Avatar
N2IXK N2IXK is offline
Technohippie
 
Join Date: Apr 2011
Location: Sittin' on the "Group W" bench...
Posts: 817
Yes, the original resistor was much bigger than a 1/2W unit. Your replacement likely burned up for this reason alone. A 5W metal film or wirewound unit would be a good replacement. As far as the 330 vs 350 ohm issue, I would tend to go with the value actually installed, rather than the parts list, assuming that the old unit looked original, and not a replacement from long ago.

The original resistor might have failed from testing a shorted tube (always run the shorts/gas test before testing emission or transconductance), or it may have been underrated from the outset. A 5W replacement would address this.

As the failed resistor is in series, I would check the 10K pot for damage, as well. It should exhibit a smooth change in resistance over its travel, with no open spots or abrupt jumps.
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:35 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.