![]() |
|
|
|
#1
|
||||
|
||||
|
With that thought in mind, or perhaps fusing the circuit; I simply broke the cathode leg and soldered in two strands of wire long enough to reach well outside the chassis. So far I have no permanent mounting and not sure what I will do there. No big deal, but it is really convenient to be able to wire in my Simpson 260 for these checks. When I'm done I just throw on a wire nut and go about my business.
I used stranded wire as that is what I had on hand. I think in the present case of the wires moving around a bit and for future routing purposes that stranded was the right decision. I hadn't thought of using a bulb really. Sounds like a good idea if you know the nature of the bulb meaning what it would look like at it's brightest lumination and 'normal'. It would look a bit raggedy, but you could simply have it dangling under the set to be observed while watching the set. For that matter I guess you could put it in the tuner indicator! LOL
__________________
"Face piles of trials with smiles, for it riles them to believe that you perceive the web they weave, and keep on thinking free" Last edited by Tubejunke; 09-27-2014 at 07:03 AM. |
|
#2
|
|||
|
|||
|
For comparison, the bulb's 'normal' is at its rated 6.3V (/ 250ma.).
The bulb would need to be located physically at the plate cap, because there's several thousand volts of pulse there. Running wires around would introduce an arcing hazard. The alternative would be the cathode leg since there's no arcing hazard and you can run wires around with no problem. But in the K leg, the bulb will introduce a few volts of negative grid bias plus a bit of negative signal feedback. This will reduce the gain a bit, which may or may not be a problem. The feedback can be cut by bypassing the bulb with an electrolytic (maybe 1000 uf @ 10V.). Of course a milliameter in the K leg would be ideal since it's essentially a short and would need no bypassing. Last edited by old_coot88; 09-27-2014 at 10:50 AM. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|