Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #3  
Old 09-25-2014, 10:39 AM
Tom Albrecht's Avatar
Tom Albrecht Tom Albrecht is offline
VideoKarma Member
 
Join Date: Mar 2010
Location: San Jose, CA
Posts: 683
The vertical output transformer and yoke are certainly worth a careful look. I'd also double check the values and wiring of any capacitors you replaced in the vertical section. Also note that the vertical centering coarse adjust switch on these sets often has very dirty contacts, so check to make sure that isn't causing a problem.

Did you replace the big Candohm resistors? They have a high failure rate in this chassis. Since you mentioned replacing all large dissipation resistors, I presume you did.

And almost certainly I imagine you have swapped out the vertical tubes.

Can you check all the voltages on the tube pins in the vertical section and see if there are any significant deviations from the service data?
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:25 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.