Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Recorded Video

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 09-12-2014, 12:08 AM
Electronic M's Avatar
Electronic M Electronic M is offline
M is for Memory
 
Join Date: Jan 2011
Location: Pewaukee/Delafield Wi
Posts: 15,496
I recall hearing that some of the betacams had issues with the surface mount lytics going bad and leaking electrolite that would corrode the board traces. If that was also an issue with the early 8MM units then you may want to address it quickly.
__________________
Tom C.

Zenith: The quality stays in EVEN after the name falls off!
What I want. --> http://www.videokarma.org/showpost.p...62&postcount=4
Reply With Quote
  #2  
Old 09-24-2014, 04:14 PM
Findm-Keepm's Avatar
Findm-Keepm Findm-Keepm is offline
Followin' the Rules...
 
Join Date: Jun 2007
Posts: 2,857
Quote:
Originally Posted by Electronic M View Post
I recall hearing that some of the betacams had issues with the surface mount lytics going bad and leaking electrolite that would corrode the board traces. If that was also an issue with the early 8MM units then you may want to address it quickly.
I replaced over 80 SMD lytics in my CCD-F series 8mm machine I bought in 1995 - and used about 2 feet of wirewrap wire replacing the runs they corroded. It still has problems in the first 2 or 3 seconds of recording, but settles down and records fine.

A set of calipers (for measuring the size of the old caps to order new ones), a bit of 90% isopropyl to clean things up, and a Digi-Key Catalog, and I had my caps ordered - Panasonics - 22 dollars in all. Then, pull out the caps and replace them one at a time using a low wattage iron, and if there is any corrosion, trace out the runs to ensure you have continuity. I had about 8-10 bad runs. Wirewrap wire worked well in threading the wire around parts and under some. Take plenty of pictures when you are disassembling - helps greatly in reassembling things. Good luck!
Reply With Quote
  #3  
Old 09-24-2014, 07:05 PM
MIPS's Avatar
MIPS MIPS is offline
VideoKarma Member
 
Join Date: Jun 2014
Location: West Canadia
Posts: 1,023
Quote:
Originally Posted by Electronic M View Post
I recall hearing that some of the betacams had issues with the surface mount lytics going bad and leaking electrolite that would corrode the board traces. If that was also an issue with the early 8MM units then you may want to address it quickly.
It's an issue with their later CCD-V5000 cameras too. I'm finding it even in the high-end cameras too from JVC like the GY-X2. Literally hundreds of them to replace...
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 08:00 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.