Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Vintage TV & Radio Tech Forum

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #2  
Old 07-16-2014, 10:24 AM
dtvmcdonald's Avatar
dtvmcdonald dtvmcdonald is offline
VideoKarma Member
 
Join Date: Nov 2012
Posts: 1,268
Some questions.

After careful examination, restuffing the chassis mounted electrolytic cans will
be a nightmare if done as described in the article mentioned in the sticky
thread at the top of this forum (remove can from chassis, uncrimp buttom) because
they are all soldered in, most at two or three places. Some are riveted in.

I'm not intending to leave the chassis bottom original looking, but I am the top,
more or less. I could do a "cut off at the base and cover the gap with
silver color tape" bit on them, but that would not look original even at a glance.

What I'm thinking of doing is just leaving them in as is, removing them
electrically, and adding terminal strips to hold the small new caps.
For the ones in the power supply, I would remove the seleniums, which are
huge, and mount the new caps, 1N4007s, and their associated dropping
resistors, on a circuit board mounted inside their cage. The rest should
easily fit under the chassis. What do people think of this ... it would be
easily cosmetically reversible if a future owner wanted to, as I'm saving all the
old parts.

Where is the Candohm resistor on the schematic?
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:07 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.