Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #4  
Old 07-08-2014, 05:25 AM
earlyfilm's Avatar
earlyfilm earlyfilm is offline
Eternal Member
 
Join Date: Jun 2011
Location: Culpeper, VA
Posts: 527
This looks to me like a vertical sweep problem, not a CRT one, although a loose and arcing connection almost anywhere could cause it.

The horizontal shift is probably from the collapsing vertical output tube changing the load on the flyback, assuming the vertical output tube uses B-boost from the damper tube.

It is hard to judge vertical linearity from this picture, however, with that said, it looks compressed at the top and stretched at the bottom.

Try substituting both vertical sweep tubes. If you don't have alternate vertical tubes, try tapping them gently and see if this changes the problem or you see internal sparking on the tube.

Visually inspect the vertical circuits for loose connections. If none are found try gently probing them with an insulated rod. Listen for the sound of arcing in the yoke assembly. You also can do this with an insulated tube for the rest of the set.

Note: The vertical output transformer may make a sound that matches this, if the plates are loose. To determine if this is a problem or not, tighten the screws slightly. If this reduces the sound, this is normal. If not, suspect an arcing transformer. (Smaller vertical output transformers don't have screws, just metal crimping.)

Have you replaced the grid coupling condenser between the vertical oscillator and the vertical output. If not, it could be breaking down.

A resistor (cathode, plate, grid bias) in the vertical output circuit could be breaking down. Check for changes in value.

If you are using the yoke that came with the Delco set, do a test with the one that came with the test tube. These are usually general purpose ones.

James
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:33 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.