![]() |
|
|
|
#1
|
||||
|
||||
|
Much too nice of a set to part out. Looks like a keeper to me.
|
|
#2
|
|||
|
|||
|
I ran across a lot of Emerson's, but never a 19" roundie. It must be the last issue 19AP4, straight gun, no ion trap.
I've seen several 19" roundie sets, Admirals, RCA's and of course, Zenith Portholes. Emerson 19" roundies, must be rare.
|
|
#3
|
||||
|
||||
|
Motorola used to make a 19 inch set. I wonder if it used the same tube?
__________________
Just look at those channels whiz on by. - Fred Sanford |
|
#4
|
|||
|
|||
|
Quote:
IIRC, Zenith/Rauland, Dumont and RCA used the same designation.
|
|
#5
|
||||
|
||||
|
Well viewing my current frustrations with my 730TV2 and the RA-110, I figured I'd set those aside for the moment and see what I can do with this set.
Much to my dismay, there are FIVE capacitors underneath with leads cut on the one end, one looks like it was just a sub to test something (sigh). Okay, not impossible, just check out the schematics and see where they go, right? First one I started on I can't figure out. It's a .05 uF 400V with the foil side cut. It comes off of the vertical linearity pot. According to both the Sams and the factory Emerson schematic, this cap shouldn't be anywhere in the circuit. I have no idea where it goes or why it would even be there. Ideas?
__________________
"Restoring a tube TV is like going to war. A color one is like a land war in Asia." |
| Audiokarma |
|
#6
|
||||
|
||||
|
Quote:
The 19AP4C was aluminized. |
|
#7
|
|||
|
|||
|
I have never seen a metal cone crt, that was aluminized.
The "C" probably only designates an improved or latest version.
|
|
#8
|
||||
|
||||
|
Quote:
19AP4C - Grey Filter Faceplate Aluminized Screen http://frank.pocnet.net/sheets/127/1/19AP4.pdf |
|
#9
|
||||
|
||||
|
For what it's worth, I had a necked 24AP4A that had an aluminized screen, so at least some metal cone tubes were being aluminized either by the manufacturers or the rebuilders.
|
|
#10
|
||||
|
||||
|
Quote:
For what it is worth, my old GE tube manual shows the following for the 24AP4: 24AP4; gray glass, single magnet ion trap. 24AP4A; gray glass, aluminized, single magnet ion trap. I doubt that rebuilders normally aluminized or even redeposited screens, anybody know of one that did? ![]() jr Last edited by jr_tech; 12-01-2014 at 12:39 AM. |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|