Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 03-13-2014, 12:09 AM
Tom Albrecht's Avatar
Tom Albrecht Tom Albrecht is offline
VideoKarma Member
 
Join Date: Mar 2010
Location: San Jose, CA
Posts: 683
I often simply hunt for an appropriate waveform somewhere in the vertical oscillator or output stage and couple it through a small value cap to the brightness control of the set. If the video signal is on the CRT cathode and brightness control on the grid, then you want a sawtooth with a rising ramp and a vertical drop. If the video is on the CRT grid and the brightness is on the cathode, then you want a signal with a falling ramp and a vertical rise. Depending on the amplitude of the signal you are grabbing, something in the range of 50 - 1000 pF will usually do it, and typically you need to add about 50-100 K in series with the lead to the cathode or grid, and couple the signal to the cathode or grid end of the resistor.

I've had a few sets where this was not successful. Sometimes the problem is that the sawtooth rise or fall is too fast, and the retrace on the screen isn't done before the blanking pulse ends. The method shown here should solve that problem, since it pulls the blanking pulse off the actual current waveform in the vertical deflection yoke. I'll keep this circuit in mind for future reference!
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 07:49 AM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.