Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Early B&W and Projection TV

Notices

We appreciate your help

in keeping this site going.
Reply
 
Thread Tools Display Modes
  #1  
Old 02-05-2014, 04:58 PM
CaryLee's Avatar
CaryLee CaryLee is offline
VideoKarma Member
 
Join Date: Dec 2013
Location: Farmington, New Mexico
Posts: 108
Quote:
Originally Posted by holmesuser01 View Post
The resistor on the tuning eye is inside the base cover. On my set, the tube was bright, but had only minute movement on the display. The new resistor brought that back.

The tube is a 6AL7-GT. It's not terribly expensive.
I've got another 6AL7-GT in the mail on the way to me..due Friday. You are absolutely correct about them being pretty cheap..shipping and all it was around $8. Much better than the eye tube for my 1938 RCA 99K! The 6U5 tube that radio uses are going for astronomical prices on Ebay..last one I bid on ended up going for over $30, but not to me.

Not sure what the deal is with my eye tube, but figure I can't really dig into it until I have one I know is good, or I could end up chasing a "problem" that doesn't exist. When I first turn the set on and it's warming up, the eye tube will light a little bit, not real bright but visible, then it fades out. It's never a real "crisp" looking display even when I can see it, and the tube display has a smeared "burned" look to it even when there's no power to it.
Reply With Quote
  #2  
Old 02-05-2014, 05:19 PM
CaryLee's Avatar
CaryLee CaryLee is offline
VideoKarma Member
 
Join Date: Dec 2013
Location: Farmington, New Mexico
Posts: 108
Spent this morning watching "Cahill, U.S. Marshall" on the DuMont, while working on adjustments to the set. I've got a big mirror sitting in front of it so I can see what affect the adjustments are having.

I want to thank everyone who has offered advice to this novice! I've been able to resurrect my grandparents old Teleset from a novelty/conversation piece/plant stand to an actual, working television!

It does seem the picture tube, while viewable, is not near "bright". I'm getting a full picture, have been able to center it in the CRT, and can get it pretty well focused. Unless there is some other factor that affects brightness, I'd say I am going to have to go on the hunt for another 19AP4. Not an easy task out here in New Mexico, where there are VERY few vintage televisions. I am VERY happy with what I have, though, considering the set has been "dead" for around half a century.

There are some very thin diagonal white lines that appear on the CRT from time to time, mostly they seem to be associated with the brightness and contrast settings. They cross the CRT from lower left to upper right. So skinny, I've not been able to photograph them. They do not distort anything on the screen. Any hints?

I've noticed that the "Brightness" control affects the focus quite a bit. Is this normal?

Lastly, when tuning, with the continuous tuner, I've noticed the picture seems to come in well, then seems to lose it's sync (get "wobbly"), then comes in good again before tuning out. I've attempted to sync the sound to the places where there is the best picture, but the sound seems to want to come in strongest closest to the "wobbly" picture. Any hints on what to check for?

Thanks!
Reply With Quote
  #3  
Old 02-05-2014, 07:04 PM
kramden66 kramden66 is offline
VideoKarma Member
 
Join Date: Nov 2010
Location: Rockaway, NJ
Posts: 1,421
your brightness focus issue and lines which are retrace lines and lack of brightness suggest a weak crt , if you are not planning on running it for hours on end and only an hour or so a day or every other day I would put a brightener on it , you will get better brightness , contrast and less of the lines and control the focus / brightness , if you had a crt tester you could see what it reads , my Dumont has a weak one so I put a brightener on it but added a resistor so its only 7 or so volts , this is enough to improve the picture and not push it that hard , at 7 volts emissions rise to good on mine, a regular brightener could be 8 or 9 volts , If you don't have one I might be able to space one.

as far as the wiggle it could be where you are at in tuning range , if you reduce the agc it may improve this as well and reduce the wobbly effect .

mike
Reply With Quote
  #4  
Old 02-05-2014, 07:24 PM
CaryLee's Avatar
CaryLee CaryLee is offline
VideoKarma Member
 
Join Date: Dec 2013
Location: Farmington, New Mexico
Posts: 108
Quote:
Originally Posted by kramden66 View Post
your brightness focus issue and lines which are retrace lines and lack of brightness suggest a weak crt , if you are not planning on running it for hours on end and only an hour or so a day or every other day I would put a brightener on it , you will get better brightness , contrast and less of the lines and control the focus / brightness , if you had a crt tester you could see what it reads , my Dumont has a weak one so I put a brightener on it but added a resistor so its only 7 or so volts , this is enough to improve the picture and not push it that hard , at 7 volts emissions rise to good on mine, a regular brightener could be 8 or 9 volts , If you don't have one I might be able to space one.

as far as the wiggle it could be where you are at in tuning range , if you reduce the agc it may improve this as well and reduce the wobbly effect .

mike
Thank you for the info!

I forgot to mention that the white lines are stationary, if that makes a difference. I still don't have access to a CRT tester/rejuvenator. Almost bought on on EBAY, but then thought I might only use it once on this set and never use it again...I don't know if I've caught the "TV bug" yet..if I have, it's going to have to continue on much smaller sets! If you don't have a spare brightener, if you could tell me what to look for, I see there are tons of them for sale on EBAY pretty inexpensively. My only concern would be blowing out the CRT I have left and then being back to nothing. But if they are pretty safe, it might be worth a shot. It's not like the CRT is going to get better all by itself..and it may be a long while, if ever, before there's anyplace to send it off for rebuild.

I was running the TV off a VCR/DVD combo with RF output..but I can't get the DVD side to work. So I was watching a VHS tape. I remember VHS wouldn't always put out the best picture even on modern color sets, particularly when they started playing around with copy protection.

My DuMont set has a "local/distance" switch on the back which I believe has to do with the "gain". I had it set to "local". When I switched it to "distance", the whole picture would start to roll.
Reply With Quote
Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 04:09 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.