![]() |
|
|
|
#1
|
||||
|
||||
|
If you connect the output of the B-T directly to the TV, do you still see the "hum bar"?
jr Edit add: I have observed occasional "hum" on strong shortwave signals, due to "hum modulation", perhaps something similar is occuring : http://home.computer.net/~pritch/shortwav.htm Last edited by jr_tech; 02-03-2014 at 02:29 PM. Reason: add link |
|
#2
|
||||
|
||||
|
My AM60-550A modulator developed the slow-moving horizontal bar after a couple of years of continuous use. Replacing the electrolytics in the power supply cured it:
http://antiqueradio.org/HomeTVTransmitter.htm Phil Nelson Phil's Old Radios http://antiqueradio.org/index.html |
|
#3
|
||||
|
||||
|
Quote:
__________________
John |
|
#4
|
||||
|
||||
|
Quote:
Phil Nelson |
|
#5
|
||||
|
||||
|
The adhesive holding the board to the chassis was pretty soft. I was able to coax the it out. Now I just wait on the replacement caps.
__________________
John |
| Audiokarma |
|
#6
|
||||
|
||||
|
Swapped 4 new filter capacitors into the modulator today, no dice
. I'm going to go looking for some external causes in the environment, dimmers, motors, etc. I was also thinking of taking the modulator to work with me and seeing if the problem persists.
__________________
John |
|
#7
|
||||
|
||||
|
On one of my B-T AM-60-550 units, I had a rolling bar which was antenna-dependent. upon installation of a proper coax run and dipole antenna, the issue went away 100 percent of the time. Prior to the antenna switch, I was using an F-connector-to-300 ohm balun and I figure that's what caused it.
|
|
#8
|
||||
|
||||
|
I do.
__________________
John |
![]() |
| Thread Tools | |
| Display Modes | |
|
|