![]() |
|
|
|
#1
|
||||
|
||||
|
Quote:
Jas |
|
#2
|
||||
|
||||
|
Quote:
According to the tracking number, the package from Surplus Sales is on schedule to arrive tomorrow. I'm looking forward to install! |
|
#3
|
||||
|
||||
|
Whichever side puts the best focus nearest to the center of the pot.
With the non-open pot in the bleader circuit, it will shift some of the various "B" voltages and you may have to tweak some of the adjustments, including the ion trap. J. |
|
#4
|
||||
|
||||
|
Quote:
I did get a MUCH better picture, though. Eye Tube still very dim. Think it's a bad tube, since I could see faint action looking directly at tube. As far as the picture goes, a lot of "ghosting", and the top of the screen bends right..I think...I've been looking at the screen in a mirror as I make adjustments out back. Gonna move resistor and try again. Don't think it's going to change picture quality much, if at all. l |
|
#5
|
||||
|
||||
|
As far as the Dumont tuning tube is concerned, you will notice that there is a resistor installed at the back of the socket. These are frequently bad, and need replacing.
|
| Audiokarma |
|
#6
|
||||
|
||||
|
Thanks!
|
|
#7
|
||||
|
||||
|
Got the new focus control yesterday, and like Phil said earlier, the shaft is a tad longer, and needs the flat filed into it. A little work with the Dremel tool and it was ready to go.
These controls from Surplus Sales of Nebraska were packaged in 1960! Talk about NOS! I almost hated to open up something that was sealed in it's package when Dwight Eisenhower was President. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|