Time to get this site upgraded, so we are passing the hat around. We appreciate any donations. Seriously, even a dollar helps. The payment page may be found here - https://www.audiokarma.org/support.html
We appreciate your help
in keeping this site going.
I have a Sencore CR161 and trying to test a 21EAP4 from a Predicta. When I set the filament voltage to 2 it jumps all the way up to 3 on the voltmeter even with the fine adjust all the way down??
Is this the no-load voltage? If so, it may come down to the proper value with the CRT connected.
Try 'blipping' the tester on for justa second with the CRT connected and see.