![]() |
|
|
|
#1
|
||||
|
||||
|
Were these sold by Olson electronics in western NY or Ohio?
It looks like Sams covered some models in the early 60s, but AM214 was not listed. Ill look up the other number, maybe its close. Those tube #s help a lot.
__________________
"When resistors increase in value, they're worthless" -Dave G |
|
#2
|
||||
|
||||
|
Not sure where they were purchased but since my family is in Western NY and it was my grandfather's equipment it could have come from a local retailer - apparently they were headquartered in Akron Ohio from what I dug up so far.
|
|
#3
|
||||
|
||||
|
IMG_0141b.jpg
Took advantage of the snow day and the cap order I received yesterday to finish the recap on the AM-214 amp (and fix the channel 2 issue I had) and do the RA-524 FM receiver. Both seem to be working fine after the surgery ![]() Any suggestions for the oxidation or whatever the dark areas are on the amp's face? Last edited by 1966C10; 01-07-2014 at 04:54 PM. Reason: content |
|
#4
|
||||
|
||||
|
Quote:
![]() You could try a VERY gentle cleaning with some Mother's Mag and Aluminum Polish, followed by a coat of clear spray lacquer to keep the panel from oxidizing again. It's worked for me with old gold tone face-plates before. |
|
#5
|
||||
|
||||
|
Quote:
From some digging it seems the same as or very similar to the Monarch SA-40 and probably a few others of that era. Would still like to find a schematic for it but with the recap it should work well for a while. |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|