Videokarma.org

Go Back   Videokarma.org TV - Video - Vintage Television & Radio Forums > Antique Radio

Notices

We appreciate your help

in keeping this site going.
 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #5  
Old 12-06-2013, 12:39 PM
Reece's Avatar
Reece Reece is offline
VideoKarma Member
 
Join Date: Jul 2004
Location: Cleona, PA
Posts: 2,178
Agreed. You do it by "neighborhoods." Divide the chassis into small areas and take a close photo of each section before starting. Then finish wiring one area as photographed before moving to the next. Take loose one end of an old wire but leave the other end connected: solder in the new wire and then route it to the other terminal where you finally remove the other end of the old wire. Best way to avoid mistakes. Follow the original lead dress to avoid feedback or hum problems. On a transformer-operated chassis, I like to make up twisted pair from hookup wire for the heater circuit to run from one socket to another where possible, ditto on runs to the power switch, all of which reduces possible hum. Can't do this with series string heaters where it's best to follow the original routing, which tends to put the first audio heater in a spot where hum should be the least.
__________________
Reece

Perfection is hard to reach with a screwdriver.
Reply With Quote
Audiokarma
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 12:15 PM.



Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2026, Jelsoft Enterprises Ltd.
©Copyright 2012 VideoKarma.org, All rights reserved.