![]() |
|
|
|
#1
|
|||
|
|||
|
Well I felt ambitious enough to remove the purity coil but that is as far as I think I will go.
From the pictures this tube almost looks brand new. And it is confirmed to be a 15GP22. What do you experts think? |
|
#2
|
||||
|
||||
|
Apart from the getter, the outward appearance of a tube is not very meaningful. I have seen cruddy, scratched-up tubes that perform like brand new, and shiny-looking tubes that were dead ducks. Looking at the getter gives you one clue, but that is not very scientific, either. A better test is whether it gives strong emission on all three of its guns, something you need a CRT tester to check. Even CRT testers don't tell the whole story. I have seen tubes that don't look so hot on a tester, but which make very acceptable pictures when installed in a working TV -- which is the ultimate tester.
Phil Nelson |
|
#3
|
||||
|
||||
|
Quote:
It is likely that when you apply voltage to the filiments, they will either light dimly and/or burn out. There is always an outside chance that I am mis-reading what I see in the photos, but I would not be optimistic. I have seen bad tubes with getters that look far better than the ones pictured in these photos. Still, you will need to test it anyhow to tell for sure.
__________________
Vacuum tubes are used in Wisconsin to help heat your house. New Web Site under developement ME http://AntiqueTvGuy.com |
|
#4
|
|||
|
|||
|
Quote:
Best of luck, and I look forward to more on this thread. |
|
#5
|
||||
|
||||
|
Curious to learn what is printed on the connector. RCA perhaps? A date code hopefully. The earliest known RCA 15GP22 has a January 1954 date code.
Pete |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|