![]() |
|
|
|
#1
|
||||
|
||||
|
Did your supply voltages ever come down closer to spec? What DC voltage do you read now on pins 4-6 of V13B(horz osc)?
|
|
#2
|
||||
|
||||
|
And if the voltages are *still* too high, perhaps use your variac to reduce until they are normal and see how the horiz behaves.
Is 10 k resistor from horiz hold to the transformer ok? How about the 50 uuf cap to the sync circuit? Does the "parts set" have a good horizontal transformer if you need it? jr |
|
#3
|
||||
|
||||
|
Quote:
I'll check the 10K resistor next. Everything on the parts set (except for the frozen controls) *looks* okay? But I haven't tested anything.
__________________
"Restoring a tube TV is like going to war. A color one is like a land war in Asia." |
|
#4
|
||||
|
||||
|
Quote:
jr 12K does not seem to be too far off, does the pot have it's full range of 20K? |
|
#5
|
||||
|
||||
|
-69 VDC on pin 4, 2.44 VDC on pin 6. Still high.
__________________
"Restoring a tube TV is like going to war. A color one is like a land war in Asia." |
| Audiokarma |
![]() |
| Thread Tools | |
| Display Modes | |
|
|